Loco Holders

£15.00

Holders are made to order

SKU: N/A Category: Tag:

Description

These are designed to stop your loco sliding around its box without masses of foam or bubble-wrap. The wheels of the loco are guided into slots which holds the loco in place, the holders are dual gauge for 32mm and 45mm. They do not clip onto any part of the loco, some foam (or similar) is required on the lid of your box to stop the loco from lifting out of the slots. Each holder has screw holes which will be tapped to receive M3 screws (screws not supplied).

Roundhouse Little John/Bulldog/Hercules Holder: Designed to fit a Roundhouse Little John/Bulldog/Hercules chassis.

HGLW Battery Electric Chassis Holder: Fits a “4-wheel drive” HGLW Battery Electric Chassis, it has a cut-out for rear axle gear and drive system.

Roundhouse Millie Holder: Fits a Roundhouse Millie chassis.

Roundhouse Billy/Katie/George Holder: Designed to fit the Roundhouse Billy/Katie/George 0-4-0 chassis.

Roundhouse Charles Holder: Fits a 2012 Roundhouse Charles with RC where the reverser servo is underneath the loco. The higher end of the holder goes towards the front of the loco, the lower back allowing for the servo at the back of the rear wheels.

Roundhouse Lady Anne/Silver Lady Holder: Designed to support an 0-6-0 Silver Lady chassis without the sprung suspension being compressed if pressure is applied from above.

Roundhouse Harrogate: Designed to fit the Roundhouse Harrogate model.

Don’t see your loco listed? You can send us details and measurements via our Contact Form and we’ll see what we can do!

Additional information

Loco Type

Roundhouse Little John/Bulldog/Hercules, HGLW Battery Electric Chassis, Roundhouse Billy/Katie/George, Roundhouse Charles, Roundhouse Harrogate, Roundhouse Lady Anne/Silver Lady, Roundhouse Millie

Reviews

There are no reviews yet.

Be the first to review “Loco Holders”